1, before starting work, the operator should check the press and work site, finishing: check the precision stamping parts, precision terminal stamping die is clean; Check the clamping of the die and the fixing of the press; Check material thickness and surface cleanliness; Check the lubrication of the press, and prepare the waste tank, and put the precision stamping parts and precision terminal blanks in the designated position for easy access.


2, when working, should always comply with safety procedures. For example, when stamping, the required safety systems should always be implemented; Work to wear work clothes, wear a good cap, work to be serious, always adhere to the post, the mind to concentrate, to prevent personal accidents.


3, strictly according to the precision stamping parts, precision terminal process regulations of the content of the operation, the work should be concentrated. Precision stamping parts, precision terminal first piece must be inspected, qualified before production, stamping process, should be carried out at any time self-inspection and special inspection, and the host can not put double material, timely clean up waste. When a fault occurs, it should be stopped immediately, reported to the relevant departments in time, and production can be started after normal recovery.


4, after the work is finished, first of all to turn off the power switch. Wipe the press and precision stamping parts, precision terminal die, apply lubricating oil to the working part of the die, sort out the parts, waste and scrap.